IP65 Waterproof Halogen Heater: 400V 2500W R7s Tube for Industrial Heat
We built this heater for the messy, loud, real world of the factory floor. The kind of place where dust, water, and constant motion are just part of the routine. So we made it tough. And compact. It’s a halogen heater, packing 2500W at 400V into a 300mm tube. That means you can squeeze serious heat into tight spots without having to compromise on power.
Power, Voltage, and Size: The Real Numbers
Here’s the thing about this 400V, 2500W setup: it throws off a ton of heat from a small footprint. The 300mm length focuses all that energy right where you need it. That helps it warm up fast and respond quickly when you flip the switch. But with that kind of power, you have to plan for it. This heater is going to demand proper cooling and airflow around it. Give it some breathing room, and it will do its job without overheating your machine.
The Build: Coated Tube and R7s Connector
The quartz tube is coated to handle the heat stress and fight off grime from the environment. That keeps the output steady, even during those long shifts. And the IP65 sealing? It’s your shield against water jets and dust. No more worrying about a little splash or grit causing an early failure. The R7s connector is the kind of no-nonsense detail you appreciate. Wire it, lock it, and you’re done. When it’s time for a replacement, you can swap it out in minutes.
Where It Shines: tough Heat for Tough Jobs
This is the heater you want on packaging lines, plastic processing equipment, or anywhere that gets a daily washdown. It gives you predictable heat with minimal downtime. Just remember, you’re getting serious heat here. Make sure your enclosure and cooling setup are ready to handle that sustained load.